Programming Three LEDs

For part 6, our task was to write programs that'll make the blue LED light on our breadboard to light.To begin, we opened the Arduino Sketch and File. The first steps was getting our materials together. The materials used were: two jumper wires; a long orange wire, short black wire, a breadboard, Arduino, USB cord and a resistor. To begin, I put the orange LED light and the resistor into the breadboard.  We then connected a long orange jumper wire and a short black jumper wire into the Arduino board. For the final step, we copied the code in the Sketch. A orange light then blinked on and off.

The picture below shows what was resulted from following these steps.