In this project assignment Ruth and I had to unplug our Arduino which was already plugged in. We had to keep our red LED plugged into pin 12 as well. Now we had to do the same thing and put an LED in another row . We are going to do the same thing in another row. Next we had to take one end of a red jumper wire and plug it into another pin on the Arduino. We were then in-trusted to connect the other end of the jumper wire and plug it into a row in the first section of the board on the Arduino (not the first two column) on the left side of the breadboard. Now we had to take one end of a resistor and plug it into the same row and then over into the next section. Finally took the positive end of a green LED (the longer leg) and plug it into that row and then connect the other end of the LED to the ground rail on the right side of the breadboard. When fully completed we got to see the two LED lights beaming at us.
No comments:
Post a Comment